 Secondary oil relief valve, Getting the sucker out |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 3d914 |
 Jan 26 2012, 07:24 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,275 Joined: 24-September 03 From: Benson, AZ Member No.: 1,191 Region Association: Southwest Region  |
Can someone verify the size of the 12-point star for the secondary oil relief valve? This is the one located on the right side of the engine between two push-rod tubes.
Found this in the PET. Item #25: (IMG:http://www.914world.com/bbs2/uploads_offsite/forums.pelicanparts.com-1191-1327627484.1.jpg) (IMG:http://www.914world.com/bbs2/uploads_offsite/forums.pelicanparts.com-1191-1327627485.2.jpg) This indicates the thread size is 16mm, so the 12-point could be 14-15mm. Mine appears to have measured at 13mm, but there are no german tools suppliers that have this size. 12mm, 14mm, but no 13mm. Couldn't find it in the Birds parts either. Just need someone to verify the correct size bit. TIA |
   |
 
|
Posts in this topic
3d914 Secondary oil relief valve Jan 26 2012, 07:24 PM
JimN73
Can someone verify the size of the 12-point star ... Jan 26 2012, 07:54 PM 3d914 Thanks, Jim. Jan 26 2012, 08:36 PM mrbubblehead i just used a small cold chisel and hammer. one li... Jan 26 2012, 10:05 PM
Jake Raby Strike sharply once with a hammer...
Insert a 3/8... Jan 26 2012, 10:13 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 05:24 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.