 Taco Plate Blues, need some tips |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 76-914 |
 Feb 10 2012, 10:26 AM
Post
#1
|
|
Repeat Offender & Resident Subaru Antagonist  Group: Members Posts: 13,508 Joined: 23-January 09 From: Temecula, CA Member No.: 9,964 Region Association: Southern California 
 |
I've had my taco plate off 3 times attempting to stem the oil leak. Each time I have used new crush washers and the paper gasket. Should the rubber O-ring be replaced each time it comes apart? One of the bolt holes is helicoiled if that means anything. I have all of Jake's Curil and locktite sealants. Which one should I be using? I spoke w/ Ron aka Slits and he recommended using studs vs bolts and to check the plate for level. Any other tips. This is my last oil leak to repair (out of 2 914's) and it is besting me. Any tips/tricks or similar experiences???
|
   |
 
|
Posts in this topic
76-914 Taco Plate Blues Feb 10 2012, 10:26 AM
Cevan As I recall, I used some type of gasket sealer on ... Feb 10 2012, 11:34 AM
Drums66
As I recall, I used some type of gasket sealer on... Feb 11 2012, 01:08 PM ejm Take a look at this thread Feb 10 2012, 01:16 PM 76-914 A million thank you's, Ed. That is exactly the... Feb 10 2012, 02:38 PM 76-914 I think I got it. At least it is holding after a 4... Feb 11 2012, 05:36 PM type47
. I now have 2 914's that haven't leaked ... Feb 12 2012, 11:29 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 04:59 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.