 Factory Hood Measurements |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| hencar |
 Feb 15 2012, 12:24 PM
Post
#1
|
|
Member  Group: Members Posts: 73 Joined: 30-May 06 From: Little Rock, Arkansas Member No.: 6,097  |
I have a friend who is struggling with adjusting his 914 front hood. He said he has two hoods and both apparently neither fit properly. I was wondering if anybody had the factory dimensions for measuring the front hood seal area.
At first I thought the front hood realease and the rubber bumpers behind the headlamps needed adjustment and told him to try that first. Then he sent me this message. "I'm talking about the distance over the seal area, The gaps to the fenders, cowl, and front panel are fine. The contour line with the fenders is good for the rear 2/3, but slowly increases to a 5/8" gap with the front lip in the forward 1/3 of the hood" Anybody have the dimensions they could send me? Or instructions if you know how to fix this problem. Thanks in advance for your help. Henry hcarraro@hughes.net |
   |
 
|
Posts in this topic
hencar Factory Hood Measurements Feb 15 2012, 12:24 PM
rick 918-S Top right side of the page is a 914 Info link with... Feb 15 2012, 12:34 PM Jeffs9146 Sounds like a cracked rear hinge mount problem to ... Feb 15 2012, 12:41 PM wingnut86 Henry,
Have him verify that front end spec to mak... Feb 15 2012, 02:00 PM
hencar Like I said I thought the hood release and the two... Feb 16 2012, 07:33 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 01:48 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.