 Bilstein shocks & Weltmeister springs, Installation Question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| chris914 |
 Sep 11 2004, 01:34 AM
Post
#1
|
|
Member  Group: Members Posts: 489 Joined: 24-July 04 From: San Diego, CA Member No.: 2,393 Region Association: Southern California  |
I'm installing a set of rear Bilstein shocks and a set of Weltmeister 140lb springs in my car.
The Weltmeister springs are shorter then the stock springs. So the spring moves all around between the top and bottom spring holder. I haven't put the car down on the ground yet but I'm assuming it will set properly when I do. My question is do I need to worry about everything seating properly? Will the spring seat correctly in the top and bottom spring holder every time I raise and lower the car? Thanks Chris. 1972 1.7L Porsche 914 1973 2.0L VW Thing http://www.cassidy-online.com |
   |
 
|
Posts in this topic
chris914 Bilstein shocks & Weltmeister springs Sep 11 2004, 01:34 AM
Racer Chris ... Sep 11 2004, 05:42 AM chris914 How do I attach them using the zip-ties. Should I ... Sep 11 2004, 10:52 AM maf914 Chris,
Check the Haynes 914 manual, page 94, for ... Sep 11 2004, 11:14 AM Racer Chris ... Sep 11 2004, 04:49 PM ArtechnikA Racer Chris I was at a local PCA meeting once, held at the Bil... Sep 12 2004, 06:14 PM Steve You shouldn't have to tie up the springs with ... Sep 12 2004, 06:50 PM maf914   |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 23rd May 2024 - 08:57 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.