 Rust how far to go?, Jacking point and H3LL hole |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| glens67 |
 Mar 12 2012, 01:54 PM
Post
#1
|
|
Newbie  Group: Members Posts: 35 Joined: 13-March 10 From: Middleton, ID Member No.: 11,462 Region Association: Rocky Mountains  |
Here are some pictures. Tried to find some post with repair pictures and failed miserably.
I am planning to cut the jack point just 1/2" below the square tube and back to about 2" past the rear hole and about 1/2" forward of the Jack point joint. The H3ll hole I think I will clean up and just overlap some sheet metal (weld). Thanks Glen (IMG:http://www.914world.com/bbs2/uploads_offsite/i166.photobucket.com-11462-1331582080.1.jpg) (IMG:http://www.914world.com/bbs2/uploads_offsite/i166.photobucket.com-11462-1331582080.2.jpg) (IMG:http://www.914world.com/bbs2/uploads_offsite/i166.photobucket.com-11462-1331582081.3.jpg) (IMG:http://www.914world.com/bbs2/uploads_offsite/i166.photobucket.com-11462-1331582081.4.jpg) (IMG:http://www.914world.com/bbs2/uploads_offsite/i166.photobucket.com-11462-1331582081.5.jpg) |
   |
 
|
Posts in this topic
glens67 Rust how far to go? Mar 12 2012, 01:54 PM
saigon71 As a starting point, hit that entire area hard wit... Mar 12 2012, 03:08 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th June 2024 - 04:50 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.