 six oil pressure sender problem |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| hars914 |
 Oct 18 2004, 06:32 AM
Post
#1
|
|
Member  Group: Members Posts: 114 Joined: 6-January 03 Member No.: 94  |
I am finishing my 2.0L six install. I was checking to make sure the wiring was OK.
When I checked the oil pressure the green light did not go on and the gauge pegged to the high side of the gauge. I have the dual sensor. When I removed the wires from the sender the gauge went to zero. I touched one of the wires to the sender case and the green light went on. The gauge I know is OK since I have not had any problems with it before and it is new. Is this a sender problem?? |
   |
 
|
Posts in this topic
hars914 six oil pressure sender problem Oct 18 2004, 06:32 AM
synthesisdv I just hooked mine up, maybe you have the gauge po... Oct 18 2004, 07:09 AM Series9 I think you have the wires for the light and gauge... Oct 18 2004, 08:09 AM ! Yup....that's what I did....swapped the wires ... Oct 18 2004, 08:15 AM hars914 I did that and same problem. The gauge pegged out ... Oct 18 2004, 08:47 AM synthesisdv did you use teflon tape or sealant on the sender t... Oct 18 2004, 08:59 AM hars914 I used teflon tape. I will check that Oct 18 2004, 01:04 PM
ein 6er does the sender match your gauge?
can you please... Oct 18 2004, 04:53 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 5th June 2024 - 04:13 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.