 Flywheel for 914-6 - Use existing or buy new? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| patssle |
 Sep 30 2012, 06:04 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 981 Joined: 28-August 09 From: Houston, TX Member No.: 10,741 Region Association: None  |
I have a 3.0L (separated from a 915) that I will be connecting to my 901 trans to install into the 914. I know the two options are to use the current 3.0L flywheel and get the KEP ring-gear. The other option is to just buy a new KEP flywheel that has the ring-gear already on it. I am running carbs so I do NOT need any sensors/timing.
Are there any reasons why one is better than the other? A new flywheel is slightly (not much) more expensive, but you get a whole new flywheel. The 911 clutch is slightly larger (228mm) but the Stage II 914 KEP clutch is 215mm but seems more than adequate (270 ft. lbs. of torque). Thanks! |
   |
 
|
Posts in this topic
patssle Flywheel for 914-6 - Use existing or buy new? Sep 30 2012, 06:04 PM
jcd914 All the 911 3.0L's used a pull clutch, not a p... Oct 1 2012, 01:02 AM Larry Hubby The 901 transmissions in our 914s use a pull clutc... Oct 1 2012, 02:13 AM Mark Henry I'm looking for a good flywheel ;)
The guys a... Oct 1 2012, 05:55 AM
9146986 It's been several years, but KEP did make a ki... Oct 1 2012, 07:04 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 02:44 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.