 Handbrake question, Pin angle? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| porschefile2010 |
 Nov 10 2012, 11:54 AM
Post
#1
|
|
Member  Group: Members Posts: 228 Joined: 26-May 11 From: Whangaparaoa, New Zealand Member No.: 13,118 Region Association: Australia and New Zealand  |
Have been trying to sort out my handbrake and found that the pin which is welded to the inside of the frame and on which the hndle pivots, is bending. It needs to be welded to hold it firmly in place.
Question is should the pin sit square to the long or should it be in line with the direction the cable goes, which is slightly inwards under the small cover that is screwed into the corner. If it is square to the long then the bush in the handle must take a hammering. Seems to me it should be on a slight angle so the line to the cable exit is straight?? Anyone had this issue before? Thanks |
   |
 
|
Posts in this topic
porschefile2010 Handbrake question Nov 10 2012, 11:54 AM
914Eric Just checked my car which I just removed everythin... Nov 10 2012, 12:25 PM bperry Yep. I just repaired mine.
The pivot has a large f... Nov 10 2012, 12:56 PM porschefile2010 Thanks to you both. That's a bit weird though.... Nov 10 2012, 01:27 PM 914Eric Mine is a 73, and it does have a stand. Here's... Nov 10 2012, 01:33 PM
porschefile2010 Thanks eric. I will check tomorrow. I should remem... Nov 10 2012, 02:15 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 29th May 2024 - 05:59 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.