 Need Help Before I Screw Up!, Roll Bar Trim Molding Removal Help |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| JawjaPorsche |
 Dec 3 2012, 06:09 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 3,463 Joined: 23-July 11 From: Clayton, Georgia Member No.: 13,351 Region Association: South East States  |
It makes a job much easier when you know what you are doing! I am going replace my sail vinyl and I need to remove the trim molding.
Looking the Roll Bar Trim Molding, there a phillips head screw at the top. (I think I can figure that out!) (IMG:style_emoticons/default/beerchug.gif) I found a picture of the Roll Bar Trim Molding. Looking at the picture there seems to be a channel at the bottom. Do you remove the screw at the top then slide the molding out at the bottom backwards toward the rear? Any help, needless to say, will be greatly appreciated! (IMG:style_emoticons/default/beer.gif) Attached image(s) 
|
   |
 
|
Posts in this topic
JawjaPorsche Need Help Before I Screw Up! Dec 3 2012, 06:09 PM
dlee6204 There is a nut up under fender you need to loosen ... Dec 3 2012, 06:16 PM Jeffs9146 :agree: Dec 3 2012, 06:31 PM Eric_Shea Small 8mm nut holds a clamp which pulls down the t... Dec 3 2012, 06:36 PM PanelBilly Be prepared for the nut to break off because its r... Dec 3 2012, 07:43 PM
JawjaPorsche That is not what I want to hear!
:huh:
B... Dec 3 2012, 07:55 PM euro911 Clean any undercoating (or other foreign residue) ... Dec 4 2012, 12:37 AM JawjaPorsche Sounds like a good plan! :beer2:
Clean an... Dec 4 2012, 05:41 AM JawjaPorsche Cleaned with Simple Green and sprayed with PB. Do... Dec 4 2012, 08:56 AM Eric_Shea If it breaks you're done. No big deal. Just ... Dec 4 2012, 09:20 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd June 2024 - 07:27 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.