 plenum removal, '76 2.0 |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| MarkG |
 Nov 11 2004, 12:25 PM
Post
#1
|
|
Member  Group: Members Posts: 314 Joined: 24-May 04 From: Colorado Springs Member No.: 2,102  |
Is it held on with bolts that go through the 2 tubes either side of the TB? If so, what size bolts or are they screws? How to remove them/plenum?
I have an air leak somewhere and want to remove the plenum to check it's sealing. New: TB, TPS, CHT, MPS, injectors, FP regulator, FI points, dizzy breaker plate, cap rotor coil wires and plugs, manifold boots and gaskets and vacuum hoses. STILL wont idle for long, hunts and dies ......just like BEFORE I replaced all the above.... close to $2K in parts....carbs looking MIGHTY nice at this point now that Colorado is dropping emission tests...... |
   |
 
|
Posts in this topic
MarkG plenum removal Nov 11 2004, 12:25 PM
2-OH! Mark:
Before you go that far...I had the same pro... Nov 11 2004, 02:07 PM MarkG cool will give it a try;
in all honesty I still ... Nov 11 2004, 04:36 PM
vsg914 Vacuum leaks will cause a high idle. Hunting for i... Nov 11 2004, 04:52 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 04:52 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.