 jack post restoration, how does this sheet metal layer up? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| qa1142 |
 Nov 12 2004, 08:13 PM
Post
#1
|
|
Whiplash  Group: Members Posts: 1,514 Joined: 1-June 04 From: Lake Zurich, Illinois Member No.: 2,140  |
Well
Dug into left jack point today. metal is layered there??? looks like long goes behind the rear sub-frame??? Top layer is rusted through in spots. Clean solid metal all the way around where the jack post support was spot welded to the subframe. Surface rust cleaned up well under the long/subframe. If I weld this 1/2 post support in, will that be good enough? What is top layer here, the rear sub-frame? what bits would I need to patch in clean metal here?? Take a look at these pictures... Attached image(s) 
|
   |
 
|
Posts in this topic
qa1142 jack post restoration Nov 12 2004, 08:13 PM
qa1142 another view Nov 12 2004, 08:15 PM qa1142 If I por15 it and weld this piece in.... Nov 12 2004, 08:17 PM Racer Chris Thats what I would do ... unless you want to start... Nov 12 2004, 09:50 PM qa1142 :bump: Only one reply? What happened you all aslee... Nov 13 2004, 09:12 AM Lou W I would think that you would want to make sure tha... Nov 13 2004, 03:35 PM Eric_Shea :agree:
Put a rust stopping agent (RUST-MORT etc... Nov 13 2004, 03:41 PM Rhodes71/914 
vsg914 Uh, Sean, today is Saturday. Nov 13 2004, 03:44 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 03:09 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.