Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Glitch
partwerks
post May 24 2013, 06:32 AM
Post #1


Senior Member
***

Group: Members
Posts: 1,593
Joined: 7-September 06
From: Grand Island, NE
Member No.: 6,787



On my conversion, the first thing I had found when it was done, that after 3 years of rubbing, the one bolt that mounts the intercooler had been left a bit too long, and had rubbed a spot on one of the wires on top of the engine, where the connector is. It had apparently controlled the fuel pump, and so I shortened the bolt and used some silicone caulking on the wire, and I thought that was the end of the story. I think it is a separate issue from these others??

I don't know if these other 3 are related to each other, or not?

Randomly, like maybe once a week, if you are driving down the Interstate, it may cut out for a second or two, and then just go on like normal.
Also, the idle speed is usually about 1,000 but sometimes it will only idle about 500 rpm.
This last one, it had not done it for about 2 months, but I went into the store and came back out, and it would not start, till I waited about 8 minutes, and then it started right up.

Any thoughts, ideas or suggestions on what it could be, or if all 3 are related to something?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 7th June 2024 - 05:34 PM