 Cam Gear Install |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Powerman |
 Dec 4 2004, 03:53 PM
Post
#1
|
|
Newbie  Group: Members Posts: 37 Joined: 24-November 03 From: Stafford, VA Member No.: 1,384  |
How hot should the gear be to fit on the crank?
I have a staight cut gear, the ID matches the OEM gear. I froze the crank in the freezer, and put the gear in the oven. Didn't work The crappy manual says 80 C or 176 F which seems too low? I tried 200 F. I tried it again at 300 F. Do I have to press it on a hydraulic press? It's a 66mm 1.8 crank. Also, the chamfered side goes towards the #3 bearing? |
   |
 
|
Posts in this topic
Powerman Cam Gear Install Dec 4 2004, 03:53 PM
Headrage Over 400 degrees on the gear. I'm putting min... Dec 4 2004, 05:31 PM Demick 400 degree oven for the cam gear, and room temp fo... Dec 4 2004, 05:32 PM Powerman I was worried about messing up the tempering going... Dec 5 2004, 07:21 PM Racer Chris I heated some vegetable oil in a pan on the stove ... Dec 5 2004, 07:46 PM
Powerman Vegetable oil in a pan on the stove worked.
Thanks... Dec 6 2004, 06:23 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th June 2024 - 11:26 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.