 remove points plate from distributor?, brain fart |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| r3dplanet |
 Sep 1 2013, 12:18 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 679 Joined: 3-September 05 From: Portland, Oregon Member No.: 4,741 Region Association: None  |
Maybe I'm having a stroke or something.
I'm rebuilding a distributor from a 1.8 liter engine for a Weber conversion project. I've done this before for the D-Jet model with trigger points and didn't have difficulty. But for whatever reason, I can't seem to yank out the two points plates as a unit. The top plate can be pulled, but not the bottom one. All of the screws are out. So am I just being dense here or am I missing something? Additionally, does anyone have any master genius plans on how to remove the metal circlip from the depths of the middle shaft? Thanks, Marcus  |
   |
 
|
Posts in this topic
r3dplanet remove points plate from distributor? Sep 1 2013, 12:18 AM
euro911 I think there's a pin you need to press out at... Sep 1 2013, 01:05 AM
gifted914
I think there's a pin you need to press out a... Sep 1 2013, 01:18 AM r3dplanet Hey gang,
Right on both counts. If only I could h... Sep 1 2013, 01:34 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 08:13 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.