 2 years later, rust repair over |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| worn |
 Nov 19 2013, 12:11 PM
Post
#1
|
|
can't remember  Group: Members Posts: 3,172 Joined: 3-June 11 From: Madison, WI Member No.: 13,152 Region Association: Upper MidWest 
 |
Here in Wisconsin the winter is always around the corner. The weekend was warm and windy, but single digit temps later this week.
Which means I will be able to weld and wrench, but I cannot paint. So after replacing trunk, floor tunnel and firewall pieces and grinding the welds smooth and fixing the clutch tube and adding the RJ mount, I shot a coat of DP40 over the inside of the tub and the floor above and underneath. I discovered that painting upside down is less burnish than welding upside down. Actually I think it is DP-50 epoxy primer (grey). I generally try to put it on below anything else like bond or high build primer. All of the rust is gone and replaced with solid metal across the whole car. So, I got that going for me. |
   |
 
|
Posts in this topic
worn 2 years later Nov 19 2013, 12:11 PM
worn
Which means I will be able to weld and wrench, bu... Nov 19 2013, 12:49 PM wndsnd
Here in Wisconsin the winter is always around the... Nov 19 2013, 03:06 PM
worn
[
So, I got that going for me.
Good for you... Nov 20 2013, 08:00 PM rick 918-S Hey! what's wrong with Ravenna? :evilgrin:... Nov 20 2013, 10:54 PM effutuo101 Flat black is a good choice!
I must have gone ... Nov 21 2013, 09:26 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th June 2024 - 06:43 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.