 Valve Adjusting Screws, Doesn't seem right |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Rhodes71/914 |
 Dec 26 2004, 10:43 PM
Post
#1
|
|
Glacier  Group: Members Posts: 1,374 Joined: 8-August 04 From: End of the Road, Alaska Member No.: 2,482  |
I'm putting back together a 2L I bought this fall. I did not split the case just new rings on the pistons. Took the heads to a local VW shop the guy cleaned them up and checked out the valves and told me they looked fairly new.
So I got the heads back on the engine and adjusted the valves. On cylinder #2 (left side of pic) I had to back the adjusting screws way out to get them correct. I have never seen them like this on any type IV I have done. Should I be concerned? And why so different than the others. Attached image(s) 
|
   |
 
|
Posts in this topic
Rhodes71/914 Valve Adjusting Screws Dec 26 2004, 10:43 PM
scott thacher check the push rod, if its not seated right it can... Dec 26 2004, 10:52 PM Aaron Cox 
  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 12:30 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.
| All rights reserved 914World.com © since 2002 |
|
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |