 Replacing sail panels, Not the vinyl |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ruby914 |
 Dec 22 2013, 03:19 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 720 Joined: 26-April 09 From: Hawthorne, Ca Member No.: 10,305 Region Association: None  |
I am thinking of replacing my sail panels.
At least one maybe both were replaced by a PO. Both had at least 1/8" of Bondo on the top 1/4 of the panel. The strange thing is there were 2 paint jobs on top of the Bondo on replaced panels. My guess is the 1st PO hammered the sails in on the top, denting them, only to fill the dents later. More so, it looks like he hammered them in a little too far? It looks like the top of the sail panel is under the top roll bar panel, I only presume this is correct? I searched for an install thread and didn't find much. I did find something mentioned about some lead over a seam? I'm not sure where that was referring to. Is there a past thread on this? Any tips, pointers, warnings? Attached image(s)  
|
   |
 
|
Posts in this topic
ruby914 Replacing sail panels Dec 22 2013, 03:19 AM
r_towle Ok, that looks tough.
Buy the panels first.
Remem... Dec 22 2013, 09:54 AM
ruby914
Ok, that looks tough.
Buy the panels first.
Reme... Dec 29 2013, 10:38 AM r_towle I doubt the targa bar is racked, it's inner pa... Dec 29 2013, 04:29 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 10:28 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.