 seal removal ?, speedo angle drive shaft |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| EJP914 |
 Nov 1 2014, 10:26 AM
Post
#1
|
|
Member  Group: Members Posts: 279 Joined: 14-June 03 From: Monroeville, PA Member No.: 821  |
Could someone please tell me how to remove this seal from the housing? This housing holds the shaft and gear that go into the transaxle and the angle drive screws into it. The Porsche replacement seal (99911303650) seems to very stiff and rigid. I thought this seal would be a flexible rubber and pull out easily and pop the new one in. And the new one looks way larger than the hole it sits in. It doesn't bend or compress in from the side.
Before I tore it all up, thought I would ask the experts. All suggestions and guidance are appreciated. EJP Attached image(s) 
|
   |
 
|
Posts in this topic
EJP914 seal removal ? Nov 1 2014, 10:26 AM
EJP914 I figured it out. There is an aluminum washer over... Nov 1 2014, 10:40 AM RobW i was going to tell you to suck on it.. :rotfl: Nov 1 2014, 10:53 AM Mikey914 Putting the new one in is tight also. I covered th... Nov 1 2014, 10:45 PM
barefoot Just got my old seal out. Removing the Aluminum w... Nov 21 2014, 11:51 AM  |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd November 2025 - 09:09 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.