 Crankshaft thrust bearing, It doesn't fit |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DavidSweden |
 Jan 25 2015, 01:00 PM
Post
#1
|
|
Member  Group: Members Posts: 479 Joined: 8-June 14 From: Sweden Member No.: 17,452 Region Association: Scandinavia  |
I was going to install the crank into the case today (2.0 GC).
I tried to mate the crank thrust bearing to mark it before sliding it onto the crank, unfortunately bearing would not fit into the case, the distance between the thrust surfaces was too narrow. the old bearing and it had a gap between the thrust surfaces of 22mm the new one is 21mm Anyone got any info/advice on this problem? (IMG:http://www.914world.com/bbs2/uploads_offsite/i1300.photobucket.com-17452-1422212435.1.jpg) |
   |
 
|
Posts in this topic
DavidSweden Crankshaft thrust bearing Jan 25 2015, 01:00 PM
Dave_Darling Sounds like the wrong bearing. Where did you get ... Jan 25 2015, 01:10 PM
Mark Henry
Sounds like the wrong bearing. Where did you get... Jan 25 2015, 01:22 PM DavidSweden
Sounds like the wrong bearing. Where did you ge... Jan 25 2015, 02:43 PM Java2570 I've got a box of Mahle bearings that are for ... Jan 25 2015, 03:23 PM ejm The bearing may be for a case that has had the thr... Jan 25 2015, 05:32 PM Mark Henry Personally I wouldn't accept an open box, obvi... Jan 25 2015, 06:45 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 11:10 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.