 2.0 Oil Leak - Taco Plate area - Advice Please |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mikedsilva |
 Apr 27 2015, 01:40 PM
Post
#1
|
|
Member  Group: Members Posts: 90 Joined: 23-February 15 From: Australia Member No.: 18,462 Region Association: Australia and New Zealand  |
Being new to these cars, (about 2 months in now) I am slowly getting to know them and work my way through the issues.
One of them, is that there is a pool of oil after the car is left sitting. Mostly, it only leaks after a drive.. when the oil is hot. I pinpointed the leak to the taco plate area.. I don't have a oil temp sender so I am not sure what is under the plate... But there is some sealant around the plate area. The sealant feels very stiff.. almost like JB Weld but I don't think it since it flexes a bit when I press on it.. I found that the leak was a pinhole in the sealant.. Should I be trying to remove all the sealant to see what is under there? Or should I just put a "patch" over it and keep an eye on it? https://www.youtube.com/watch?v=8kOhdj88D_E |
   |
 
|
Posts in this topic
mikedsilva 2.0 Oil Leak - Taco Plate area - Advice Please Apr 27 2015, 01:40 PM
Spoke There is a gasket there plus a couple of aluminum ... Apr 27 2015, 01:52 PM stugray How close are you to your next oil change?
You wi... Apr 27 2015, 01:54 PM
saigon71
How close are you to your next oil change?
You w... Apr 27 2015, 02:12 PM type47 And watch the torque on the mounting bolts, you do... Apr 27 2015, 02:35 PM Dave_Darling A big O-ring, plus a paper gasket, plus two sealin... Apr 27 2015, 07:46 PM mikedsilva
A big O-ring, plus a paper gasket, plus two seali... Apr 27 2015, 08:03 PM Old Yella Think you may be rooted mate.
The case is alumini... Apr 27 2015, 09:33 PM mikedsilva I think you may be right.. but will dig it all out... Apr 28 2015, 03:16 AM mikedsilva update...
i drained the oil, and removed the seal... Jul 1 2015, 04:48 AM 02loftsmoor
update...
i drained the oil, and removed the sea... Jul 2 2015, 12:55 PM SLITS Instead of bolts, I put studs in to avoid the poss... Jul 1 2015, 06:09 AM 914Sixer I found that that had an even bigger piece missing... Jul 2 2015, 03:12 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st November 2025 - 11:51 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.