 undersize holes for press fit bushings, Trust me this is Porsche 914 related |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Harpo |
 Jun 20 2015, 03:54 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,304 Joined: 21-August 11 From: Motor City aka Detroit Member No.: 13,469 Region Association: None  |
When I went to remove my hood hinges the bolts had seized to the hinges. To prevent this from happening again I'm going to install bushings (bronze or similar) in my hood hinges. Because I want to make sure the bushing doesn't move I want to drill an undersize hole but I don't know how much smaller.
The bushing OD is 15.03mm is a 15.00 drill enough of an interference? Otherwise the next size down is 14.5mm Thanks David |
   |
 
|
Posts in this topic
Harpo undersize holes for press fit bushings Jun 20 2015, 03:54 PM
toolguy .03mm is .0012 inch. . it might fit if you freeze... Jun 20 2015, 04:26 PM
bdstone914
.03mm is .0012 inch. . it [u]might fit if you fr... Jun 20 2015, 04:56 PM Harpo Thanks for the suggestions. I do have a spare hin... Jun 20 2015, 06:39 PM r_towle Are you planning to take the hood off a lot in the... Jun 20 2015, 09:21 PM Harpo Once the car is painted and the hood has been refi... Jun 21 2015, 04:46 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st July 2025 - 07:45 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.