 Any tips for extending a thead tap? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| patssle |
 Feb 13 2016, 02:09 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 981 Joined: 28-August 09 From: Houston, TX Member No.: 10,741 Region Association: None  |
I need to thread tap my bumpers (M12 1.5) to clean out the rust. Is there a socket or extension that works with these? I did the rear bumper with a 8mm socket but it's slipping on the front bumper not being a perfect fit and as the rust is a little tougher.
If very much possible without spending $40 on a socket set that I'll never use again! Thanks! |
   |
 
|
Posts in this topic
patssle Any tips for extending a thead tap? Feb 13 2016, 02:09 PM
Darren C You need a basic collet tap wrench like this...
h... Feb 13 2016, 02:18 PM Wyvern I have had really good luck just going to the hard... Feb 13 2016, 02:25 PM zipedadoo What I usually do is find a nut that's a littl... Feb 13 2016, 02:30 PM
patssle
What I usually do is find a nut that's a litt... Feb 14 2016, 07:10 PM The Cabinetmaker You'll do better with a thread chase, not a ta... Feb 13 2016, 04:19 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 01:16 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.