 Help- persistent brake line fitting drip |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| SKL1 |
 May 16 2016, 10:28 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,610 Joined: 19-February 11 From: north Scottsdale Member No.: 12,732 Region Association: Upper MidWest 
 |
Been chasing a slow drip from the banjo fitting on top of the "proportioning valve" on the rear bulkhead.
I've replaced the 10mm and 12mm ID washers a couple times to no avail. It is a PITA working in that tight spot but the fitting is as tight as I can get it, but still has a frustrating slow drip... Any kind of gasket material (like the blue stuff) to smear on the washers to help?? Did I mention I HATE working with brake fluid???? |
   |
 
|
Posts in this topic
SKL1 Help- persistent brake line fitting drip May 16 2016, 10:28 PM
Garland It's been said before " I wish I would ha... May 16 2016, 10:44 PM Mike Bellis It may help to anneal the copper washers with a to... May 16 2016, 10:55 PM
r_towle Bellis,
Start thread with loads of details of old... May 16 2016, 11:00 PM  |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th June 2024 - 04:00 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.