 Steering Hub Spacer? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rruffer |
 Aug 20 2016, 06:06 AM
Post
#1
|
|
Newbie  Group: Members Posts: 8 Joined: 2-June 16 From: Bernardsville, NJ Member No.: 20,063 Region Association: North East States  |
I installed a Momo 8002 hub with the horn/directional turn off ring from my OEM steering wheel. Either due to the ring fitment or cast of the hub, turning the wheel creates a rubbing against the column controls. So sometimes the horn would go off or my high beams would flash. I've sorted some of this out with electrical tape or bending contact plates to avoid the inadvertent contact. I think a better solution, though, would be to space the hub out just a little.
My question is whether the hub actually rests against the C'clip on the steering shaft, so I could insert a washer or two to space out the hub, or is the shaft and hub a tapered fit? Any thoughts or suggestions? Thank you, as always, to the amazing wealth of knowledge on the Board!! |
   |
 
|
Posts in this topic
rruffer Steering Hub Spacer? Aug 20 2016, 06:06 AM
ThunderbirdDrive I'm experiencing the very same problem since I... Aug 20 2016, 07:22 AM
rruffer I haven't noticed any free play, but there may... Aug 20 2016, 08:22 PM oakdalecurtis It's been a long time since I installed my Mom... Aug 20 2016, 10:08 PM larryM
I think a better solution, though, would be to s... Aug 21 2016, 11:55 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 23rd May 2024 - 10:04 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.