 914-6 Conversion |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Coloradocurt |
 Jun 2 2017, 02:55 PM
Post
#1
|
|
Member  Group: Members Posts: 65 Joined: 20-November 16 From: Castle Rock, Colorado Member No.: 20,603 Region Association: Rocky Mountains  |
On a 914-6 conversion which will be running headers (instead of heat exchangers), (1) are there covers available to block off the outlets from the engine cover for the heater flex-tubes which would be used if there were going to be heat exchangers, and (2) covers to close off the holes in the engine tin on both sides where those flex hoses would be routed down to the heat exchangers?
And an alternative on that 2nd question, is anyone offering those engine tin with no holes for a much cleaner application? Thanks, Curt |
   |
 
|
Posts in this topic
Coloradocurt 914-6 Conversion Jun 2 2017, 02:55 PM
mepstein Most of the conversion tin does not have the holes... Jun 2 2017, 05:44 PM
wndsnd
Most of the conversion tin does not have the hole... Jun 4 2017, 12:58 PM Travis Neff I got mine from rennspeed on eBay
http://www.ebay... Jun 2 2017, 07:19 PM porschetub
I got mine from rennspeed on eBay
http://www.eba... Jun 3 2017, 01:30 AM patssle Spend $100 or make your own cap. I made my ow... Jun 2 2017, 07:55 PM Travis Neff Hmm mine seem ok. One needs a touch of trimming. Jun 3 2017, 01:56 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 01:27 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.