 Help with rear wheel bearing, New wheel bearing has wobble |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| thinlie |
 May 14 2005, 12:05 PM
Post
#1
|
|
Newbie  Group: Members Posts: 14 Joined: 16-May 03 From: Fairfield, CA Member No.: 704  |
Doing the rear 5 lug conversion. Everything came off without a hitch. Old bearing was a little tight in there, but came off with a little persuasion. Fitted the new bearing in and the hub no problem. The problem now is the hub has a little wobble in it. The bearing is in there nice and tight but the wobble is coming from the bearing itself. Its an SKF rear wheel bearing with a split race. Did a search here and pilican, one said to torque the bearing and hub. Is this true? And if so, to how much. Appreciate any comments. Thanks.
Mark |
   |
 
|
Posts in this topic
thinlie Help with rear wheel bearing May 14 2005, 12:05 PM
jim912928 Ok..per the factory manual there are probably thes... May 14 2005, 12:19 PM thinlie Am I to assume that the hubs in there now without ... May 14 2005, 02:55 PM xsboost90 you didnt pop the inner race apart at any time did... May 14 2005, 03:18 PM Racer Chris Yes. Until you tighten the stub axle there is not... May 14 2005, 03:18 PM Eric_Shea http://www.914world.com/bbs2/h... May 14 2005, 08:53 PM
Aaron Cox yep. i was worried too... 230 ft lbs or so and MIN... May 14 2005, 10:23 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st May 2024 - 08:15 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.