 Help! Marelli dist install in a 914-6, How to install a Marelli dist |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| skier2.0 |
 Oct 20 2017, 04:13 PM
Post
#1
|
|
Newbie  Group: Members Posts: 34 Joined: 30-May 14 From: United States Member No.: 17,422 Region Association: MidAtlantic Region  |
I can't remember (I'am an old F#%$) and can find any info on reinstalling a Marelli in a 6. The manual only shows a Bosch. It says to get TDC Z1 piston #1, rotor arm must point to approximately in the direction of the rear edge of the blower. Then turn the dist housing left until points just open. The rotor arm should then be vertically over the notch on the dist housing.
The Marelli has no notch? Do I just get #1 piston to TDC ZL1 and point the rotor at #1 wire on the cap. Thanks in advance,Rick |
   |
 
|
Posts in this topic
skier2.0 Help! Marelli dist install in a 914-6 Oct 20 2017, 04:13 PM
bretth I have one on my 2.2 but it hasn't been run in... Oct 20 2017, 04:39 PM
porschetub You got it ,that's the only way really IF you ... Oct 20 2017, 11:36 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 11:37 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.