 Removing driveshaft at transmission, Need some help |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914 RZ-1 |
 May 7 2018, 05:15 PM
Post
#1
|
|
Porsche Padawan  Group: Members Posts: 683 Joined: 17-December 14 From: Santa Clarita, CA Member No.: 18,230 Region Association: Southern California  |
1. How do I get the drive shaft separated from the transmission at the transmission (not the wheel side)? I've got all the bolts loose. Haynes manual says to insert a blade or Chisel. Where?
2. Does the rubber boot come off? How? Cut the clamp holding it? 3. Do I need to take the wheel off? Thanks!  |
   |
 
|
Posts in this topic
914 RZ-1 Removing driveshaft at transmission May 7 2018, 05:15 PM
Travis Neff right here, that is the paper gasket, a flat blade... May 7 2018, 05:19 PM LowBridge it has 2 roll pins holding it on the spline so doi... May 7 2018, 05:26 PM bretth On mine I just lay a 2x4 against the side of the C... May 7 2018, 07:57 PM Boomingbeetle You don’t need to take the wheel off. If you fid... May 7 2018, 09:40 PM porschetub Deadblow hammer on the joint nearer the axle.if th... May 7 2018, 10:18 PM Larmo63 The built up muck on these acts like a sort of glu... May 7 2018, 10:29 PM Dr Evil You can carefully wedge a blunt flathead screw dri... May 8 2018, 11:22 AM
914 RZ-1 I got it. I used a chisel and dead blow hammer. I ... May 8 2018, 07:49 PM Dr Evil
I got it. I used a chisel and dead blow hammer. I... May 8 2018, 08:57 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 08:08 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.