PMB and excellent support, That pesky 13mm nut to loosen on rear calipers |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
PMB and excellent support, That pesky 13mm nut to loosen on rear calipers |
eyecolor |
Nov 3 2018, 08:30 AM
Post
#1
|
Eyecolor Group: Members Posts: 80 Joined: 15-August 08 From: Wilmington,DE Member No.: 9,425 Region Association: None |
First of all, a thank you to PMB for providing me some small parts for my rear calipers at no charge after re-building them over 5 years ago. Promise to make it up to you.
In trying to install the spring to my E brake I saw a pin was broken off. Searching this forum I saw an article on how to drill it out and replace it with the same bit used in the process. Worked beautiful. Artcle written by none other than Eric Shea of PMB! My issue is now the 13mm nut that you must loosen to adjust the 4mm hex screw to move the outer pad, jusr will not retighten. Any thoughts !!!! Thanks so much George Ozer Wilmington,DE |
Lo-Fi Version | Time is now: 7th June 2024 - 08:09 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |