 Trunk rear floor, Where to cut the tin worm out? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Stoddy |
 Jun 13 2020, 04:35 PM
Post
#1
|
|
All things Porsche!  Group: Members Posts: 53 Joined: 30-May 18 From: Monmouth (UK) Member No.: 22,173 Region Association: England  |
Hello all, I hope everyone is well and safe.
Here in the U.K, THE COLONEL is coming along. Question. Do I cut the rear section of the trunk floor out near the middle, or is there a seem to un stich? I see the spot welds along the sides and the rear edge, but can’t see a join near the middle section. Any advice as usual, most welcome. Cheers, Stoddy (IMG:style_emoticons/default/beer.gif) Attached image(s) 
|
   |
 
|
Posts in this topic
Stoddy Trunk rear floor Jun 13 2020, 04:35 PM
9146C Restoration Design have a "how-to" video... Jun 13 2020, 05:03 PM bkrantz I cut just aft of the cross brace flange, and then... Jun 13 2020, 09:20 PM Stoddy Thanks gents, I haven’t bought the replacement p... Jun 15 2020, 05:17 PM 9146C If I had to do it again, I would do what @bkrantz... Jun 15 2020, 06:22 PM barefoot My panel from AA, here's how much I used:
Note... Jun 16 2020, 10:30 AM SA-914 I still needed to cut out a bit more on the right.... Jun 16 2020, 10:52 AM SA-914 RD panel Jun 16 2020, 10:55 AM cary My .02c for today, less is more. Only replace what... Jun 16 2020, 11:26 AM Lg914 We found it easiest to remove the back section of ... Jun 17 2020, 05:19 PM
Montreal914 Above is exactly what I am currently doing. Seems ... Jun 17 2020, 08:56 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 02:17 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.