 License plate lights, How do these mount |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Morph914 |
 Sep 10 2020, 02:06 PM
Post
#1
|
|
Member  Group: Members Posts: 435 Joined: 22-August 16 From: St Augustine, FL Member No.: 20,326 Region Association: South East States 
 |
In the picture we are looking at the bottom of the rubber top for the rear bumper, where the license plate lights are supposed to mount.
Beacause I did not disassemble these from the old top, I do not know how they were installed. First off these holes in the rubber top do no line up with the holes on the lights, and, as you can see, on right side there is only one hole. I know these are the right lights because the electrical connectors on the wires match up with the lights. Should I just center these and install the screws into the rubber? Thanks, John   |
   |
 
|
Posts in this topic
Morph914 License plate lights Sep 10 2020, 02:06 PM
IronHillRestorations Looks to me as though you have a defective bumper ... Sep 10 2020, 05:41 PM jim_hoyland What size screws do the new 914Rubber bumper tops ... Sep 10 2020, 05:54 PM BeatNavy I think this is a "known issue" with the... Sep 10 2020, 05:57 PM Mikey914 They are limited by the size needed for the light ... Sep 10 2020, 05:59 PM dr914@autoatlanta.com yup easy to drill into the rubber and that is what... Sep 10 2020, 06:00 PM
Morph914 Thanks for all the replies. I purchased both bumpe... Sep 10 2020, 08:06 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 5th June 2024 - 06:45 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.