 Axle CV joint bolts question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| roundtwo |
 Aug 10 2021, 04:14 PM
Post
#1
|
|
Member  Group: Members Posts: 282 Joined: 9-February 20 From: Petaluma, CA Member No.: 23,905 Region Association: Central California 
 |
Hello
Can someone kindly tell me … see pic. 1. The bolts that hold this together, should I use lock tight on them. The heads arent drilled to wire fasten for back up safety. 2. torque spec for the bolts. ? Assuming it’s the same on both ends of the axle ? Close to finishing up my caliper/ brake/ rotor/ bearing install on all four corners  Attached thumbnail(s) 
|
   |
 
|
Posts in this topic
roundtwo Axle CV joint bolts question Aug 10 2021, 04:14 PM
76-914 You can drill them out while its convenient or ord... Aug 10 2021, 04:22 PM roblav1 Never ever put locktite on those! Use new Sch... Aug 10 2021, 07:41 PM roundtwo Thanks for all your help. I had no idea what those... Aug 10 2021, 11:27 PM Mikey914 The Schoor washers are a good way to go. We do sel... Aug 11 2021, 12:58 AM Bartlett 914 I do agree on the proper washers. I have discovere... Aug 11 2021, 10:24 AM
brant I doubt the parts store carries those Schnorr wash... Aug 11 2021, 04:13 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th June 2024 - 12:06 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.