 Windshield install, Mispunched trim keeper hole |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Morph914 |
 Dec 30 2021, 11:50 AM
Post
#1
|
|
Member  Group: Members Posts: 435 Joined: 22-August 16 From: St Augustine, FL Member No.: 20,326 Region Association: South East States 
 |
I am in the process of preparing for my windshield install and when installing the trim keepers I noticed that the lower driver side hole was mispunched, instead of a clean hole like all the others this one pushed in some of the metal. I don’t believe the trim piece will lock into the opening. I think I will have to drill a new hole unfortunately. Shall I drill above or below the original hole?
  The install of the trim keepers is going well, I am using a small socket to set the clip and then using a punch to push in the pin.     |
   |
 
|
Posts in this topic
Morph914 Windshield install Dec 30 2021, 11:50 AM
Mikey914 I would go beside not abouve or below. The height ... Dec 30 2021, 11:58 AM
Morph914
I would go beside not abouve or below. The height... Dec 30 2021, 01:06 PM Montreal914 Thank you for sharing the process.
Good luck and ... Dec 30 2021, 02:14 PM Morph914 What is being used for primer on the windshield gu... Dec 30 2021, 02:28 PM PanelBilly When I visited Black Forest Racing a few weeks ago... Dec 30 2021, 03:28 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st May 2024 - 10:13 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.