 Reassembling Shifter to shaft, What am I doing wrong? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Deusexmachina77 |
 Jan 20 2023, 01:20 PM
Post
#1
|
|
Member  Group: Members Posts: 93 Joined: 30-March 22 From: Chicago Member No.: 26,426 Region Association: Upper MidWest 
 |
My shifter was broken at the weld, so I replaced it.
I followed the directions someone posted about replacing the springs, which worked like a charm. Now, I'm trying to get it all back together. My engine is out for a rebuild so the shaft is loose. 1. The linkage to the shifter, should that be set at a certain angle? And how tight should that nut and bolt be? 2. Trying to get the shaft in the linkage seems to be impossible. I can only think of trying to set it and then tap it in from the firewall. But I can't do both things at once. Am I missing something here? Thanks, Victor |
   |
 
|
Posts in this topic
Deusexmachina77 Reassembling Shifter to shaft Jan 20 2023, 01:20 PM
Deusexmachina77
My shifter was broken at the weld, so I replaced ... Jan 20 2023, 11:09 PM
Rob-O It does go on in a certain ‘angle’, but you wo... Jan 21 2023, 09:16 AM Deusexmachina77
Personally I use Clay Perrine’s method. It’... Jan 21 2023, 01:01 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 07:33 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.