 /6 Heat exchanger, repair and installation |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| michel richard |
 Aug 14 2005, 01:23 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,291 Joined: 22-July 03 From: Longueuil, Québec Member No.: 936  |
It's a little rainy today, in Montreal, so I'm getting a few things done. The original /6 heat exchangers I got from Jon Lowe were in pretty good condition, except that one had a hole in it.
So I brazed in a patch. I like brazing for this sort of work because it's easy and leaves a low profile patch. Unfortunately, I left a couple of little gaps after the first go-around. Attached image(s) 
|
   |
 
|
Posts in this topic
michel richard /6 Heat exchanger Aug 14 2005, 01:23 PM
michel richard So I went over it again with the braze rod. Anoth... Aug 14 2005, 01:25 PM michel richard The result. This is as good as I can get it. Aug 14 2005, 01:26 PM michel richard On the green car, I currently run headers, modifie... Aug 14 2005, 01:30 PM michel richard Back from the chrome shop. I simply had them dip ... Aug 17 2005, 12:59 PM
michel richard Paint drying ! Aug 17 2005, 01:00 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th November 2025 - 10:06 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.