 No starty, Help me get my thinking cap on |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| TravisNeff |
 Aug 26 2005, 04:22 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 5,082 Joined: 20-March 03 From: Mesa, AZ Member No.: 447 Region Association: Southwest Region 
 |
I just put in my 2.0 from the white car. Hasn't been run in a year or so, but it ran great when I drove it last. New CHT and ballast resistor, checked out MPS, ECU and wiring. It is a 73 2.0 with all checked and matched components.
It turns over, fuel pump runs but won't catch. I popped the valve cover on cyl number one and reset my timing, so I know I am close enough to start and am not 180 degrees off. Wiring is all where it should be, I know I need to check the CHT again with a meter, and set the dwell again to be sure. What else should I check? |
   |
 
|
Posts in this topic
Travis Neff No starty Aug 26 2005, 04:22 PM
bondo Narrow it down by pulling plugs after an attempt a... Aug 26 2005, 05:01 PM Travis Neff Relay board was fine as of about 4 days ago, trigg... Aug 26 2005, 09:03 PM trekkor Make sure the plug wires are right.
( is the roto... Aug 26 2005, 09:20 PM Travis Neff Rotor is there, first thing I checked. Plug wires... Aug 26 2005, 09:24 PM Joe Sharp Hey Travis: I never think time is wasted on a 914 ... Aug 26 2005, 11:33 PM Joe Ricard Ground wire to the tranny? Aug 27 2005, 07:19 AM Travis Neff Thanks Joe, you are right - back to basics.
I hav... Aug 27 2005, 12:21 PM
Travis Neff http://www.914world.com/bbs2/... Aug 27 2005, 06:25 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 02:09 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.