 EGR line, can it be bent or bypassed |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| nebreitling |
 Aug 12 2003, 10:25 PM
Post
#1
|
|
Member Emeritus  Group: Members Posts: 3,314 Joined: 26-March 03 From: San Francisco Member No.: 478  |
hi all
quick question. im installing a bursch muffler on my 75 2.0 -- and [what i think is the] EGR line (it looks like aluminum pipe, connects onto the exhaust and then goes to the engine bay) doesn't match up to where it "should be" on the bursh. rather, this line is over by the passenger rear wheel, where it connected onto my old exhaust. so, i figure i have two options: try to bend it into its new position (looks tough, maybe a little propane torch would help convince it); or just plug the litter f-cker up (on the exhaust, too). what would you do? thanks, one day i'll stop sucking everyone dry for knowledge and start actually making a contribution to this board! nathan |
   |
 
|
Posts in this topic
nebreitling EGR line Aug 12 2003, 10:25 PM
nebreitling Anyone? who's removed their EGR? Aug 13 2003, 11:08 AM tryan is it the air pump hook up? post a picture. Aug 13 2003, 12:39 PM tryan does it look like any of this? air injection junk Aug 13 2003, 12:45 PM nebreitling thanks for the reply
it's definitely the EGR ... Aug 13 2003, 01:16 PM Marty Yeoman I have done just that on my'75 1.8 L-Jet. All ... Aug 13 2003, 01:39 PM nebreitling thanks for the reply. yeah, i think that might... Aug 13 2003, 01:43 PM RustyWa Nathan, the EGR stuff is off of my car also. By ... Aug 13 2003, 02:10 PM nebreitling thanks, eric
what you show in the picture is exac... Aug 13 2003, 03:20 PM nebreitling oh, one more thing eric.
the pic shows that you c... Aug 13 2003, 03:35 PM RustyWa Ahh...good question. When I got my car, I didn... Aug 13 2003, 03:53 PM nebreitling <... Aug 13 2003, 04:17 PM
Marty Yeoman Before you cut the tube off, check to see if it co... Aug 14 2003, 01:44 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 05:28 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.