 need some welding help/advise |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Jeroen |
 Nov 21 2005, 07:24 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 7,887 Joined: 24-December 02 From: The Netherlands Member No.: 3 Region Association: Europe  |
ok... having some trouble making nice welds
well, partially below is a pic of a recent weld usually, I can get a nice weld going. good penetration etc. and then out of the blue, it'll start sputtering and globs of weld start to stack making thick ugly welds what's my problem? - hand/eye coordination - wire speed - amp setting any tips/pointers? please help me out... I hate the look of ugly welds and it's a huge PITA to grind 'm out and start over Attached image(s) 
|
   |
 
|
Posts in this topic
Jeroen need some welding help/advise Nov 21 2005, 07:24 PM
Bleyseng You are using a shielding gas set up??
Clean the s... Nov 21 2005, 07:27 PM Racer Chris Could it be impurities on the surface, and not so ... Nov 21 2005, 07:33 PM McMark You're using a MIG, right? I know that when I... Nov 21 2005, 07:38 PM scotty b Amperage looks O.K. from pic, clean clean clean. D... Nov 21 2005, 07:45 PM bondo Is that weld thru primer or regular paint? If it... Nov 21 2005, 07:46 PM trekkor Looks like you're out of gas.
KT Nov 21 2005, 07:47 PM Jeroen surfaces are clean
no rust or paint (except a thin... Nov 21 2005, 07:53 PM TimT You need to clean to a nice shiney substrate befor... Nov 21 2005, 07:55 PM scotty b Liner runs through the sleeve, and the wire runs t... Nov 21 2005, 08:00 PM trekkor Get some scrap of the same guage.
Turn up the volt... Nov 21 2005, 08:05 PM McMark The liner is what keeps the MIG wire from jamming ... Nov 21 2005, 08:07 PM MecGen Dude wazzup
120 volt machine, wire size?... Nov 22 2005, 04:08 AM Jeroen Nov 22 2005, 06:46 AM sgomes All I can add to this is your bad welds look ten t... Nov 22 2005, 08:15 AM
fiid http://www.914world.com/bbs2/h... Nov 22 2005, 11:18 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 11:08 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.