 Bad pin day, Two strut-ball joint pins sheared |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| billd |
 Feb 2 2006, 12:59 AM
Post
#1
|
|
Member  Group: Members Posts: 327 Joined: 25-May 05 From: Palo Alto, CA Member No.: 4,145  |
The one on the left is a brand new pin from Pelican. It sheared at less than 30ft-lbs. The one on the right is the old pin that I then tried to re-use. It sheared between 40 and 44 ft-lbs.
The correct torque for these is 47 ft-lbs. Right? Attached image(s) 
|
   |
 
|
Posts in this topic
billd Bad pin day Feb 2 2006, 12:59 AM
messix maybe inch pounds? Feb 2 2006, 01:00 AM Cap'n Krusty 18 ft/lbs, just like any other 8mm threaded 8.8 b... Feb 2 2006, 01:15 AM bondo Maybe 47 ft-lbs is the torque of the nut at the bo... Feb 2 2006, 01:19 AM billd The torque on the bottom nut is 180 ft-lbs.
The... Feb 2 2006, 02:31 AM blitZ Feb 2 2006, 05:55 AM 9146986 That was a spendy FUBAR! Feb 2 2006, 09:37 AM billd Thanks for the advice guys. That was pretty stupi... Feb 2 2006, 12:31 PM
Mueller Feb 2 2006, 12:38 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 01:06 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.