 heater motor, connection |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| toon1 |
 Feb 25 2006, 05:23 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,849 Joined: 29-October 05 From: tracy,ca Member No.: 5,022  |
The connection has two wires, brown and green. The brown wire gets 12 volts. I can't get any reading off the green wire.
where does this wire connect? The relay activates when the red lever in the car is pulled up. |
   |
 
|
Posts in this topic
toon1 heater motor Feb 25 2006, 05:23 PM
toon1 http://www.914world.com/bbs2/ht... Feb 25 2006, 08:17 PM rhodyguy try disconnecting the 2 fan wires on the fan, and ... Feb 25 2006, 10:43 PM toon1 thanks for the reply, I know the motor is good alr... Feb 25 2006, 11:13 PM toon1 Feb 25 2006, 11:16 PM toon1 what am I missing? I have power to the relay,relay... Feb 26 2006, 10:45 AM toon1 http://www.914world.com/bbs2/ht... Feb 26 2006, 12:22 PM rhodyguy with the fan wires disconnected. have you checked ... Feb 26 2006, 12:44 PM toon1 I pulled the defrost lever in the cab out of the t... Feb 26 2006, 01:14 PM rhodyguy i don't know what else to suggest. cap the j-t... Feb 26 2006, 01:35 PM toon1 Thank's for the help, it confuses me too, ever... Feb 26 2006, 01:41 PM rhodyguy ok. i'm looking at p160 in my haynes. item #65... Feb 26 2006, 01:48 PM toon1 Just thought of something, does every thing on the... Feb 26 2006, 01:49 PM SirAndy Feb 26 2006, 02:27 PM toon1 <... Feb 26 2006, 05:59 PM SirAndy Feb 26 2006, 06:54 PM toon1 I did switch the relay's to make sure, same re... Feb 26 2006, 07:17 PM toon1 Fuses are good. checked both of them end to end an... Feb 26 2006, 07:18 PM SirAndy Feb 26 2006, 09:09 PM ClayPerrine On a 73 and later, there is a jumper wire in the 1... Feb 26 2006, 09:18 PM toon1 Son of a B.!!
Can you plug the connec... Feb 26 2006, 09:28 PM ClayPerrine If you plug the engine harness in, then you risk s... Feb 26 2006, 09:31 PM ClayPerrine If you have an early engine harness (72 and older)... Feb 26 2006, 09:33 PM toon1 I will try the jumper, I have a 73.
Thanks so ... Feb 26 2006, 10:15 PM
toon1 I put a jumper across pin 10 and 11, and got 12v, ... Feb 27 2006, 06:13 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 11:11 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.