 Tranny Question, The minimum parts if.......? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Michael J |
 Jul 3 2006, 12:46 AM
Post
#1
|
|
Welcome to 2007  Group: Members Posts: 268 Joined: 23-November 04 From: Olympia, WA Member No.: 3,166  |
.....If my 901 shifts ok into 1st, great into 3rd thru 5th but into 2nd has to be slow motion or it grinds most of the time. If i'm lucky I was figuring on a gasket set, a 1st gear synchro band (while I'm at it) a 2nd gear synchro band and for good measure an input shaft seal. That's what I'm ordering. I will pull it apart tomorrow. Is that a reasonable parts list if bearings, dogteeth, sliders and all are OK? This is the first time into one of these and I am a little apprehensive. I have read many of the archive posts and yes I read Red Beards article. So I think I have some good reference material. I just won't know for sure what else to order unless it just falls apart in my hand.
Advice appreciated |
   |
 
|
Posts in this topic
Michael J Tranny Question Jul 3 2006, 12:46 AM
Bleyseng Probably is the minimum parts but add the shift ro... Jul 3 2006, 08:36 AM Dr Evil QUOTE
Cap'n Krusty You'll need a tranny gasket set, unless you al... Jul 3 2006, 09:45 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st May 2024 - 05:38 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.