 Installed Engine Today |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mharrison |
 Oct 12 2003, 09:07 PM
Post
#1
|
|
Why do I bother????  Group: Members Posts: 633 Joined: 8-September 03 From: Madison, MS Member No.: 1,123  |
Here it is this morning:
(IMG:http://home.jam.rr.com/mharrison/914Resto/EngineTransBehindCarResized.JPG) Here it is now: (IMG:http://home.jam.rr.com/mharrison/914Resto/EngineInCarResized.JPG) Axle shafts are hooked up, speedo and clutch cables are connected, Plan to put the heat exchangers, shift linkage, and Dells on tommorow. (I work at a bank and have the day off !!!!) I know the engine compartment looks terrible, but I haven't decided on a color yet. Factory is Irish Green, but with the flares and five lugs I'm going to add, what is the point in keeping the COLOR stock??? The engine compartment is currently Irish Red....Irish Green showing through the thin film of Red paint the PO splashed in there. I think he just took the lid off and threw the can towards the engine compartment. |
   |
 
|
Posts in this topic
mharrison Installed Engine Today Oct 12 2003, 09:07 PM
echocanyons Nice sparkley engine and trans! Oct 12 2003, 09:10 PM Andyrew Looks really nice! Now take it back out and pa... Oct 12 2003, 09:11 PM rhodyguy well done. it shows you were hard at it today. dam... Oct 12 2003, 09:24 PM mharrison Well, I have to admit, the paint I wound up using ... Oct 12 2003, 09:26 PM mharrison Yeah, I thought REALLY hard about the Irish Green,... Oct 12 2003, 09:27 PM 3d914 M,
Looks good, despite the rough paint. Just be s... Oct 12 2003, 10:42 PM Charles Deutsch The motor looks so much simpler with carbs. What a... Oct 12 2003, 11:16 PM James Adams I guess I better get those wheels packed up and se... Oct 13 2003, 06:21 AM mharrison This started life in Germany as a 1.7. Here's ... Oct 13 2003, 09:28 AM Bleyseng Be sure to get the A/F mix set right on those carb... Oct 13 2003, 12:24 PM Charles Deutsch If you do the dyno testing, please post the graphs... Oct 13 2003, 01:13 PM mharrison I wouldn't think that 48x38 would be too big f... Oct 13 2003, 01:33 PM
Tom Perso A set of 44x36 heads will do just fine from Headfl... Oct 13 2003, 04:58 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th June 2024 - 11:22 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.