 No oil pressure on rebuild |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dadsscooter |
 Sep 28 2006, 05:27 PM
Post
#1
|
|
Newbie  Group: Members Posts: 7 Joined: 28-September 06 From: Michigan Member No.: 6,938  |
I haven't any oil pressure on reuilt 2.0. Had run for 15 seconds and when gauge didnt register shut it down to investigate. No oil pressure was confirmed by cranking engine with oil relief valve out... NO OILl! Also pulled valve cover and it was DRY! Had installed HD oil pump and gears turned fine when installed. I did however adjust the end play after installing the pump.
I had never pulled the oil pressure control valve from the case when rebuilding. Could this be it? Could the oil pump drive possibly become disengaged from the cam??? I realize any corrective action will most likely require removing my newly installed engine but am looking for any possible suggestions to follow. Fairly new to the air cooled scene. Please respond if you can help. Thanks, Mike |
   |
 
|
Posts in this topic
dadsscooter No oil pressure on rebuild Sep 28 2006, 05:27 PM
Cap'n Krusty Loosen the oil filter until there's a gap. Cr... Sep 28 2006, 06:01 PM
dadsscooter   |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd November 2025 - 10:47 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.
| All rights reserved 914World.com © since 2002 |
|
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |