 rear main seal, help with rear main seal. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| runfaster |
 Dec 27 2006, 07:21 PM
Post
#1
|
|
Newbie  Group: Members Posts: 47 Joined: 29-March 06 From: oregon Member No.: 5,789  |
Ok guys-i need help with installing the rear main seal. replaced once with stock ering with no special procedures and it leaked. replaced with stock victor reinz with a light coat of hondabond(let set up for 3 days) and it leaked.
what is the trick here? 1. The ering was a little bit thinner than the victor reinz-10mm vs. 11.5mm. 2. The original was an ering. 3. Is there a special method for using permetex or the hondabond type of sealent? Any help would be appreciated, because i have been working on this pos for about 9 months and i am running out of stuff to replace. i am so close to having a daily runner, but i can't get this seal right.......HELP.......... Thanks, craig |
   |
 
|
Posts in this topic
runfaster rear main seal Dec 27 2006, 07:21 PM
ejm I've never used any sealant... are you sure it... Dec 27 2006, 07:30 PM
runfaster
I've never used any sealant... are you sure i... Dec 27 2006, 07:36 PM runfaster i am going to drop everything tomorrow and maybe t... Dec 27 2006, 08:03 PM Lawrence When installing those the seal and flywheel o-ring... Dec 27 2006, 08:26 PM Dr Evil Hey Man,
I might as well post what I PMed you on ... Dec 27 2006, 08:36 PM runfaster evil to the rescue......nice and conscise........t... Dec 27 2006, 08:51 PM runfaster i will take some pics and post them....should get ... Dec 27 2006, 08:52 PM Krieger914 When you install the seal it needs to go in straig... Dec 27 2006, 09:25 PM runfaster
When you install the seal it needs to go in strai... Dec 27 2006, 09:40 PM Marty Yeoman The best way I've found to reproduce a good fl... Dec 28 2006, 12:10 AM McMark
The best way I've found to reproduce a good f... Dec 28 2006, 01:18 AM jr91472
The best way I've found to reproduce a good ... Dec 28 2006, 07:55 AM McMark For clarity.
The red arrow on the seal:
Touch... Dec 28 2006, 02:05 AM McMark The flywheel o-ring goes where the teal color is. Dec 28 2006, 02:08 AM RonD Since your there you might replace transmission se... Dec 28 2006, 04:28 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 23rd May 2024 - 05:37 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.