 Tips and Tricks for removing heat exchanger head studs, without breaking them! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| computers4kids |
 Jan 25 2007, 09:34 AM
Post
#1
|
|
Love these little cars!  Group: Members Posts: 2,443 Joined: 11-June 05 From: Port Townsend, WA Member No.: 4,253 Region Association: None  |
Prepping a 2ltr to go back in and I would like to replace all the studs that hold the heat exchangers on. Tips Welcome! -- Don't want to snap one.
I was going to just double nut each stud to try to remove it--is there a better way? Not a whole lot of room to work with. Perhaps a soft tap on the head to loosen? Thanks |
   |
 
|
Posts in this topic
computers4kids Tips and Tricks for removing heat exchanger head studs Jan 25 2007, 09:34 AM
Eric_Shea Double nut and a MAPP torch or better. Get things... Jan 25 2007, 09:42 AM McMark :agree: heat up the aluminum to ease its grip. Pe... Jan 25 2007, 12:12 PM Rand On the stubborn bolts I've dealt with, it help... Jan 25 2007, 12:18 PM ChrisNPDrider :agree: :agree:
I did the PB Blaster 2-4x over a... Jan 25 2007, 12:21 PM
ClayPerrine I am a bit of a caveman when it comes to removing ... Jan 25 2007, 07:24 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 01:41 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.