 2.7L/3.0L with Cis and engine lid, anyone got it to fit? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Justinp71 |
 Feb 22 2007, 10:34 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,584 Joined: 11-October 04 From: Sacramento, CA Member No.: 2,922 Region Association: None 
 |
I have a 75 cis motor and the cis boot gets in the way of the engine lid latch.. so I had to remove it.
now the lid is up about 1/2" on the drivers side and I have to push it down to open the trunk, not to mention that I now also have to prop the engine lid up. I was going to move the latch over, but I don't have a welder... maybe I will have to get one. (I do have welding experience) Anyone have any experience/suggestions with this? Attached image(s)  
|
   |
 
|
Posts in this topic
Justinp71 2.7L/3.0L with Cis and engine lid Feb 22 2007, 10:34 PM
Martin Baker I have a welder here if you want to use it... Feb 22 2007, 10:35 PM John Will your shift rod allow you to lower the engine ... Feb 22 2007, 10:43 PM SLITS I removed the engine lid latch, rear trunk torsion... Feb 23 2007, 07:39 AM Dr Evil I have a 74 2.7 with CIS in my car, you need to re... Feb 23 2007, 10:20 AM ClayPerrine There is a way to use Audi parts to move the CIS a... Feb 23 2007, 10:32 AM Dr Evil Um, DAMN. And I though mine was a bit of work, yik... Feb 23 2007, 10:37 AM pete-stevers i put a 3.0 with cis in....simple solution...drop ... Feb 23 2007, 10:55 AM SLITS Here you go ........
http://www.rccauto.com/engin... Feb 23 2007, 11:30 AM
Justinp71 Slits... I like your setup, it seems easy and fast... Feb 23 2007, 11:50 AM SLITS
Slits... I like your setup, it seems easy and fas... Feb 23 2007, 01:20 PM pete-stevers oil cooler yes... is it needed i don't know..... Feb 23 2007, 12:27 PM Justinp71 I guess there is no problem with moving the motor ... Feb 23 2007, 05:59 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 11th June 2024 - 09:37 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.