 Paint adhesion issue |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DSM |
 May 2 2007, 12:36 PM
Post
#1
|
|
Newbie  Group: Members Posts: 29 Joined: 28-April 07 From: NTX Member No.: 7,700  |
OK, I've stripped down to metal, done the required metal bumping, little polyester filler to get it straight. Two coats of self etching primer went on last night.
Today I find the self etching primer blistering off of the bare metal in spots. I'm sure the surface was clean. WTF??? I used a Mar Hyde product that came in a qt can. Did not thin it as it looked pretty thin already. I noticed the place where I bought it don't carry this stuff anymore. Perhaps this is why. Back to sanding... I am wondering what's the order. Self etching primer, filler (build up) primer, epoxy primer then base/clear? Have I got this right? Having a fear of the stuff coming off afterwards now. |
   |
 
|
Posts in this topic
DSM Paint adhesion issue May 2 2007, 12:36 PM
Vacca Rabite
OK, I've stripped down to metal, done the req... May 2 2007, 12:42 PM skline :agree:
You must have had something on there, th... May 2 2007, 01:04 PM
So.Cal.914
:agree:
You must have had something on there, t... May 3 2007, 12:01 PM mills914/s Use soap and water then let it dry then some solve... May 2 2007, 01:16 PM John I have no experience with the product that you are... May 2 2007, 01:16 PM Twystd1 Here is a heads up on silicone.
If you ever spray... May 2 2007, 02:32 PM tdgray Also... make sure that the rags you are using to w... May 2 2007, 02:34 PM Matt Romanowski Make sure your air supply is clean too. You should... May 2 2007, 02:43 PM DSM It was degreased, power washed, washed with soap a... May 3 2007, 10:54 AM oemexp Twystd1 made some good suggestions to look for as ... May 3 2007, 11:24 AM DSM Mark, What do you use to etch the metal? May 3 2007, 11:33 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th June 2024 - 03:31 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.