Found some melted wires in the loom, What are they and where do they go??? |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Found some melted wires in the loom, What are they and where do they go??? |
JBart |
May 9 2007, 08:47 PM
Post
#1
|
UNDER CONSTRUTION Group: Members Posts: 110 Joined: 9-October 06 From: Wildomar Ca. Member No.: 7,019 |
Ok the day started out good I decided to clean out the engine compartment while I Have the engine out I got almost all the grease out and decide to shake the wire loom to get the water out from the presure washer. I then take the plastic loom off of the wire to find wires melted together. The wire which melted itself to all the other wires is grey. there is a picture below and then I found another wire which was not hooked up to anything it's BLK/red coming off pin # 13 out of the relay board. Is that the wire which should be running my fuel pump? By the way I'm running carbs so if I remember I need to grd. one of the other pins to make this wire HOT . Is that correct?
Sorry for jumping all over the place I found way to many lil' prob. today. Thanks, jbart Attached image(s) |
Lo-Fi Version | Time is now: 28th May 2024 - 12:46 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |