 The mystery disks in the floors, Finally found the answer |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
Model Specific Information
914/4: 70 71 72 73 74 75 76 914/6: 70 71 72
| ClayPerrine |
 Jun 7 2007, 10:29 PM
Post
#1
|
|
Life's been good to me so far.....  Group: Admin Posts: 15,515 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille 
 |
I was talking with Al Zim (owner of Zim's Autotechnic) and he clued me in on what those big round holes in all the floor panels are for!! Seems that they used a very similar setup on the 356, and he had seen them in use.
When the tub was built, they mounded the various pieces to the jig with a twist lock setup. Then the rest of the tub was assembled to those pieces. When they were done, they pulled the tub off the jig, and installed the plugs into the panels. He even showed me pictures of a partially assembled 356 tub on the jig, and he showed me the same plugs in the floor of one. |
   |
 
|
Posts in this topic
ClayPerrine The mystery disks in the floors Jun 7 2007, 10:29 PM
SirAndy another one to scratch off the list!
:trophy... Jun 9 2007, 11:34 AM 9146986 OK, so how about the holes in the very front bulkh... Jun 9 2007, 05:20 PM Pat Garvey
I was talking with Al Zim (owner of Zim's Aut... Jun 9 2007, 08:48 PM
McMark I'd love to see a scan of that 356 picture. Jun 9 2007, 10:35 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 05:05 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.