 Speedo angle drive, doesn't want to come off of the trans |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jimtab |
 Aug 31 2007, 11:44 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 3,477 Joined: 5-January 03 From: Pacifica, California Member No.: 91 Region Association: Northern California  |
I am trying to change the speedo angle drive because it went to puppy heaven and I can't seem to get it to release...I took out the "lock bolt" in the back...duh but, I turn and turn on the nut on the piece into the trans and Nothing. the outer part of it came off of the part that's hooked to the trans (I think that may have had something to do with the problem....so where do I go from here...I hate to just start prying and banging without knowing what the hell I'm doing....I'm sure it's something simple and I'll feel stupid when you tell me so here's your chance to "do" me...HELP!
OK, never mind, the search engine started working again and I found Mikes VERY cogent article...relax, smoke em if you got em..... |
   |
 
|
Posts in this topic
jimtab Speedo angle drive Aug 31 2007, 11:44 PM
SirAndy
I took out the "lock bolt" in the back.... Sep 1 2007, 12:56 AM Dr Evil Dude, what are you doing? Arent you out of your sk... Sep 1 2007, 01:39 AM jimtab Mike....you have no itdea....now I can't get t... Sep 1 2007, 10:05 AM Cap'n Krusty Why are you removing the drive pinion? It's a... Sep 1 2007, 10:13 AM
jimtab
Why are you removing the drive pinion? It's ... Sep 1 2007, 12:03 PM Dr Evil Jim, it would have been easier to leave the angle ... Sep 1 2007, 11:35 AM jimtab
Jim, it would have been easier to leave the angle... Sep 1 2007, 12:01 PM Cap'n Krusty Ask first, act later. Act first, then ask, then c... Sep 1 2007, 07:12 PM jimtab
Ask first, act later. Act first, then ask, then ... Sep 2 2007, 12:01 AM jimtab Success, the baby is born, the part is installed a... Sep 2 2007, 09:18 PM Dr Evil Good talking to ya today, man! Glad it worked ... Sep 2 2007, 09:23 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th June 2024 - 03:23 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.